Firefly开源社区

标题: RK3568网卡设置百兆失败 [打印本页]

作者: run 时间: 2023-1-12 09:44
标题: RK3568网卡设置百兆失败
将eth1 网口设置成百兆网口，但更新系统后，仍然显示千兆网口，未配置成功

gamco 配置：

&gmac0 {
233       phy-mode = "rgmii";
234       clock_in_out = "input";
235 //    clock_in_out = "output";
236
237 /*    snps,reset-gpio = <&gpio2 RK_PD3 GPIO_ACTIVE_LOW>; */
238       snps,reset-gpio = <&gpio0 RK_PD5 GPIO_ACTIVE_LOW>;
239       snps,reset-active-low;
240       /* Reset time is 20ms, 100ms for rtl8211f */
241       snps,reset-delays-us = <0 20000 100000>;
242
243       assigned-clocks = <&cru SCLK_GMAC0_RX_TX>, <&cru SCLK_GMAC0>;
244       assigned-clock-parents = <&cru SCLK_GMAC0_RGMII_SPEED>, <&gmac0_clkin>;
248       pinctrl-names = "default";
249       pinctrl-0 = <&gmac0_miim
250                   &gmac0_tx_bus2
251                   &gmac0_rx_bus2
252                   &gmac0_rgmii_clk
253                   &gmac0_rgmii_bus
254                   &gmac0_clkinout>;
255
256       tx_delay = <0x3c>;
257       rx_delay = <0x2f>;
258
259       phy-handle = <&rgmii_phy0>;
260       status = "disabled";
261 };

      时钟配置：：

433       gmac0_clkin: external-gmac0-clock {
434                compatible = "fixed-clock";
435                clock-frequency = <50000000>;
436                clock-output-names = "gmac0_clkin";
437                #clock-cells = <0>;
438       };
439

结果:仍显示千兆网卡

firefly@firefly:~$ dmesg |grep eth1
[ 5.969001] rk_gmac-dwmac fe2a0000.ethernet eth1: No Safety Features support found
[ 5.969023] rk_gmac-dwmac fe2a0000.ethernet eth1: IEEE 1588-2008 Advanced Timestamp supported
[ 5.969350] rk_gmac-dwmac fe2a0000.ethernet eth1: registered PTP clock
[ 5.971211] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready
[ 6.995233] rk_gmac-dwmac fe2a0000.ethernet eth1: Link is Up - 1Gbps/Full - flow control rx/tx
[ 6.995319] IPv6: ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready

tchip_askquestions

log.txt.gz

309 Bytes, 下载次数: 0, 下载积分: 灯泡 -1 , 经验 -1

作者: Liuth 时间: 2023-1-12 14:24
请查看SDK中docs/GMAC/Rockchip_Developer_Guide_Linux_GMAC_Mode_Configuration_CN.pdf文档学习3568的RMII模式设置

作者: dengkx 时间: 2023-1-12 20:10
可以在系统设置成100M：ethtool -s eth1 speed 100 autoneg off

欢迎光临 Firefly开源社区 (https://dev.t-firefly.com/)