|
【技术讨论】
Core-1126-JD4核心板eth0 RX packet:0,无接收
发表于 2021-9-8 14:44:09
浏览:19141
|
回复:21
打印
只看该作者
[复制链接]
楼主
使用Core-1126-JD4核心板配合自己画的底板,使用RTL8211F芯片,RV1126可以实现网络的自动识别。但是不能接收,使用ifconfig查看,RX packet:0一直为0。求解。C:\Users\Administrator\Desktop\1.png
原理图:
C:\Users\Administrator\Desktop\2.png
- [ 5.487692] Generic PHY stmmac-0:00: attached PHY driver [Generic PHY] (mii_bus:phy_addr=stmmac-0:00, irq=POLL)
- [ 5.488389] rk_gmac-dwmac ffc40000.ethernet: rk_get_eth_addr: mac address: c6:53:1b:b3:40:b5
- [ 5.488426] rk_gmac-dwmac ffc40000.ethernet: device MAC address c6:53:1b:b3:40:b5
- [ 5.498453] dwmac4: Master AXI performs any burst length
- [ 5.498489] rk_gmac-dwmac ffc40000.ethernet eth0: No Safety Features support found
- [ 5.498518] rk_gmac-dwmac ffc40000.ethernet eth0: IEEE 1588-2008 Advanced Timestamp supported
- [ 5.499736] rk_gmac-dwmac ffc40000.ethernet eth0: registered PTP clock
- [ 6.504589] rk_gmac-dwmac ffc40000.ethernet eth0: Link is Up - 100Mbps/Full - flow control rx/tx
复制代码 |
|