RK3328修改串口波特率之后桌面不显示

xinzhiling222

开发版：ROC-RK3328-CC
默认的串口波特率是1500000，换了几个工具都看不到打印，所以就该了下内核中波特率地方，修改的地方如下：
--- a/arch/arm64/boot/dts/rockchip/rk3328-firefly-core.dtsi
+++ b/arch/arm64/boot/dts/rockchip/rk3328-firefly-core.dtsi
@@ -61,7 +61,7 @@
                rockchip,wake-irq = <0>;
                /* If enable uart uses irq instead of fiq */
                rockchip,irq-mode-enable = <0>;
-               rockchip,baudrate = <1500000>;  /* Only 115200 and 1500000 */
+               rockchip,baudrate = <115200>;  /* Only 115200 and 1500000 */
                interrupts = <GIC_SPI 127 IRQ_TYPE_LEVEL_LOW>;
                status = "okay";
        };
进不了命令行，桌面不显示时，串口最后的打印如下：
[    9.072606] sdio: host isn't  initialization successfully.
[    9.078097] failed to power up DHD generic adapter, max retry reached**
[    9.084781] unregister wifi platform drivers
[    9.089075] wifi_platform_bus_enumerate device present 0
[    9.094389] ======== Card detection to remove SDIO card! ========
[    9.100486] sdio: host isn't  initialization successfully.
[    9.105978] ======== dhd_wlan_deinit_plat_data ========
[    9.111213] dhd_module_init: Failed to load the driver, try cnt 0
[    9.117341] dhd_module_init: Failed to load driver max retry reached**
[    9.123870] dhd_module_init: Exit err=-19

麻烦了解的大神帮忙分析一下，谢谢

18333604834

怎么搞