无法禁用RK3588的待机状态

tfirst

硬件：AIO-3588Q

软件：buildroot (sdk 版本：v1.0.6f.)

在系统运行的时候，单击power按键，会使系统进入待机状态，现在想要禁止单击Power按键系统进入待机状态，按照文档《RK3588 系统待机配置指南》（Rockchip_RK3588_Developer_Guide_System_Suspend_CN.pdf）中的步骤，在kernel的dts文件rk3588-firefly-aio-3588q-mipi101-M101014-BE45-A1.dtsi，增加如下设置：

&rockchip_suspend {

       status= "disabled";

       rockchip,sleep-debug-en= <0>;

};

或：

&rockchip_suspend {

       status= "disabled";

       rockchip,sleep-debug-en= <0>;

       rockchip,sleep-mode-config= <0>;

       rockchip,wakeup-config= <0>;

};

均无法奏效，即：单击power键后，系统仍然进入待机状态，在串口打印打印如下信息：

[ 463.265257] [dhd] [wlan0] dhd_pri_stop : tx queue stopped

[ 463.265297] [dhd] [wlan0] dhd_stop : Enter

[ 463.265307] [dhd] dhd_stop: ######### called for ifidx=0 #########

[ 463.265316] [dhd] dhd_rtt_deinit: ENTER

[ 463.265324] [dhd] dhd_rtt_deinit: EXIT, err = 0

[ 463.267814] [dhd] CFGP2P-ERROR) wl_cfgp2p_disable_discovery :  do nothing, not initialized

[ 463.268132] [dhd] dhd_stop: making dhdpub up FALSE

[ 463.268152] [dhd] dhd_tcpack_suppress_set: TCP ACK Suppress mode 3 ->mode 0

[ 463.268160] [dhd] dhd_tcpack_suppress_set: TCPACK_INFO_MAXNUM=10,TCPDATA_INFO_MAXNUM=10

[ 463.268210] [dhd] [wlan0] wl_android_wifi_off : in g_wifi_on=1,on_failure=1

[ 463.268222] [dhd] dhd_rtt_deinit: ENTER

[ 463.268229] [dhd] dhd_rtt_deinit: EXIT, err = 0

[ 463.268241] [dhd] dhd_bus_devreset: == Power OFF ==

[ 463.268286] [dhd] dhd_bus_stop: making DHD_BUS_DOWN

[ 463.268442] [dhd] dhd_dpc_kill: tasklet disabled

[ 463.272664] [dhd] dhd_bus_devreset: making DHD_BUS_DOWN

[ 463.272684] [dhd] dhd_bus_devreset: WLAN OFF Done

[ 463.272696] [dhd] wifi_platform_set_power = 0, delay: 0 msec

[ 463.272705] [dhd] ======== PULL WL_REG_ON(-1) LOW! ========

[ 463.272715] [WLAN_RFKILL]: rockchip_wifi_power: 0

[ 463.272724] [WLAN_RFKILL]: rockchip_wifi_power: toggle = false

[ 463.272731] wifi power off

[ 463.377269] [WLAN_RFKILL]: wifi shut off power [GPIO20-0]

[ 463.377316] [dhd] [wlan0] wl_android_wifi_off : out

[ 463.377390] [dhd] [wlan0] dhd_stop : Exit

[ 463.394825] PM: suspend entry (deep)

[ 463.395803] Filesystems sync: 0.000 seconds

[ 463.395840] [dhd] dhd_pm_callback: action=3, suspend=1, suspend_mode=1

[ 463.395856] [dhd] dhd_conf_set_suspend_resume : op_mode 5, suspend 1,suspended 0, insuspend 0x6, suspend_mode=1

[ 463.397279] Freezing user space processes ... (elapsed 0.002 seconds)done.

[ 463.399428] OOM killer disabled.

[ 463.399438] Freezing remaining freezable tasks ... (elapsed 0.137seconds) done.

[ 463.536926] printk: Suspending console(s) (use no_console_suspend todebug)

INFO:   BL31: v2.3():v2.3-499-ge63a16361:derrick.huang

INFO:   enter: cfg=0x4000024, sleeptimes:1

INFO:   armoff_ddrpd

INFO:   slp_from_uboot

INFO:   pmu debug

INFO:   io_ret (0x0)

INFO:   GPIO POWER INFO:

INFO:           not config

INFO:   GPIO0_INTEN: 0xffff 0xffff 0xfe7e 0xf7ff 0x0 0xc02e302d

INFO:   GPIO1_INTEN: 0xffff 0xffff 0xffff 0xffff 0x0 0x44ec0c30

INFO:   GPIO2_INTEN: 0xffff 0xffff 0xffff 0xffff 0x0 0xffcef4

INFO:   GPIO3_INTEN: 0xffff 0xffff 0xffff 0xffff 0x0 0xd0047b9f

INFO:   GPIO4_INTEN: 0xffff 0xffff 0xffff 0xffff 0x0 0xe09c02e6

INFO:    IRQ_EN: 251

INFO:    IRQ_EN: 250

INFO:    IRQ_EN: 248

INFO:    IRQ_EN: 247

INFO:    IRQ_EN: 282

INFO:    IRQ_EN: 272

INFO:    IRQ_EN: 313

INFO:    IRQ_EN: 312

INFO:    IRQ_EN: 311

INFO:    IRQ_EN: 310

INFO:    IRQ_EN: 309

INFO:    IRQ_EN: 292

INFO:    IRQ_EN: 321

INFO:    IRQ_EN: 365

01INFO:   pmu_power_domains_suspend 1000 pd_st=0x24dfffff repair_st=0xfa900001 idle_st=0xbffffqst=0x28000

2abcde3456789aINFO:    PMU1_PWR_CON(0x1) PMU1_CRU_PWR_CON(0x30)PMU1_WAKEUP_INT_CON(0x101)

PMU2_BUS_IDLE_ST(0x27fffff 0x0)PMU2_BUS_IDLE_ACK(0x27fffff 0x0) PMU2_PWR_GATE_ST(0x6cffffff 0x0)

PMU2_BUS_IDLE_CON(0x0 0xf980 0xf007) PMU2_BIU_AUTO_CON(0xffff0xffff 0x7)

PMU2_PWR_GATE_CON(0x0 0x1000 0x3)

PMU2_VOL_GATE_CON(0x7 0x0 0x3)

PMU2_QCHANNEL_PWR_CON(0x0)PMU2_QCHANNEL_STATUS(0xfe0007f)

PMU1_DDR_PWR_CON(0x747 0x747 0x747 0x747)

PMU1_DDR_PWR_SFTCON(0x900 0x900 0x9000x900)

PMU1_PLLPD_CON(0xffff 0x3)

PMU2_PWR_CON1(0xfe)

PMU2_DSU_PWR_CON(0x3)

PMU2_CORE_PWR_CON0(0x1 0x1)

PMU2_CORE_AUTO_PWR_CON0(0x0 0x0)

PMU2_CLUSTER_IDLE_CON(0x75)

INFO:   PMU0_PWR_CON(0x0) PMU0_WAKEUP_INT_CON(0x0)

PMU0_DDR_RET_CON(0x0 0x0)

PMU1_GRF_SOC_CON2(0x7777)PMU0_GRF_OS_REGS9(0x5599e70f)

9aS

penguin

sed -i 's/#HandlePowerKey=.*/HandlePowerKey=ignore/g' /etc/systemd/logind.conf

tfirst

penguin 发表于 2023-6-19 17:39
sed -i 's/#HandlePowerKey=.*/HandlePowerKey=ignore/g' /etc/systemd/logind.conf

我的系统是buildroot(kernel+weston)，不是Android，也不是Ubuntu或Debian，所以没有这个配置文件